Document ID
APT-DS-CXP-DEV-0001
Revision
1.0
IP version
2.2.0
Release date
November 2026
Chapter 5: Example Designs and Software

5.5Software

The core comes with a firmware driver for setup and control, supplied on purchase, for MicroBlaze, Zynq-7000 and Zynq UltraScale+ MPSoC processors. It identifies the core and its build, services the interrupts, receives control commands and sends acknowledges, sends events, runs the line rate change, starts and stops the stream, and reads the status. The example designs use it, and the basic camera adds a working command loop with the CoaXPress bootstrap registers, so it doubles as the skeleton of your camera firmware.