Document ID
APT-DS-CXP-DEV-0001
Revision
1.0
IP version
2.2.0
Release date
November 2026
Chapter 3: Interfaces and Timing

3.3Interface descriptions

3.3.1Video input

Table 3-5.AXI4-Stream video slave video_in.
PortDirWidthDescription
video_in_clkin1Video clock, any frequency ≥ pixel rate / VID_PPC, no relation to the word clock
video_resetnin1Active-low reset on video_in_clk
video_in_tdatainMAX_TDATA_WIDTHUG934 beat: VID_PPC pixels, pixel 0 in the LSBs
video_in_tvalidin1Beat valid
video_in_treadyout1Low while the video FIFO is full; the core takes a beat on every clock with both high
video_in_tuserin1Start of frame: first beat of the first line
video_in_tlastin1End of line: last beat of every line

3.3.2AXI4-Lite control and interrupt

Table 3-6.Register interface and interrupt.
InterfaceDirWidthDescription
s_axislaveaddr 12, data 32AXI4-Lite. Write address and write data are accepted in either order. A refused access answers SLVERR (see Register interface); a read the register block does not answer within 255 clocks answers SLVERR instead of hanging the bus
aclkin1Register clock, free-running; the frequency set in the GUI
aresetnin1Active-low reset on aclk
cxp_dev_intout1Interrupt, active high level; drops for 4 clocks after each ISR write and returns while sources are pending
Table 3-7.Low-speed uplink from the CoaXPress front end.
PortDirWidthDescription
ls_rx_inin1Uplink data from the front end on the FMC
ls_clk_ddrin1Uplink clock recovered by the front end

3.3.4Transceiver wrapper

Table 3-8.Connections to the supplied transceiver wrapper. Connect them as in the example designs.
InterfaceDirTypeDescription
GT_TX_DATA_Moutbus32-bit words and K flags to the transmitter
tx_outclk2inclockWord clock, line rate / 40
tx_outclk2_resetinresetReset of the word clock domain from the wrapper
GT_DYN_RECONFIG_Mout/inDRPDRP master used for the line rate change
drp_clkinclockDRP clock
reset_TX_PLLoutresetPLL and datapath reset request. Must reach the wrapper’s transmit PLL and datapath reset