Document ID
APT-DS-CXP-HOST-0001
Revision
1.0
IP version
2.2.1
Release date
November 2026
Chapter 3: Interfaces and Timing

3.3Interface descriptions

3.3.1Transceiver wrapper

Table 3-5.Connections to the supplied transceiver wrapper. Connect them as in the example designs.
InterfaceDirTypeDescription
user_GTH_RX_Datain/outbusReceived 32-bit words and K flags of the connection, and the word alignment control
rx_outclk2inclockWord clock, line rate / 40
rx_outclk2_resetinresetReset of the word clock domain from the wrapper
user_GTH_DYN_RECONFIGout/inDRPDRP master used for the line rate change
drp_clkoutclockDRP clock to the wrapper
reset_PLLoutresetPLL and datapath reset request. Must reach the wrapper’s PLL and datapath reset

3.3.2AXI4-Lite control and interrupt

Table 3-6.Register interface and interrupt.
InterfaceDirWidthDescription
s_axislaveaddr 12, data 32AXI4-Lite. Write address and write data are accepted in either order. A refused access (unmapped offset, empty FIFO read, full FIFO write, a connection count the build does not have) answers SLVERR; a read the register block does not answer within 255 clocks answers SLVERR instead of hanging the bus
aclkin1Register clock, free-running, independent of every other clock
aresetnin1Active-low reset on aclk
cxp_intout1Interrupt, active high level; drops for 4 clocks after each ISR write and returns while sources are pending

3.3.3Video output

Table 3-7.AXI4-Stream video master video_out and the format port.
PortDirWidthDescription
video_out_clkin1Video clock, any frequency ≥ pixel rate / VID_PPC, no relation to the word clock
video_resetnin1Active-low reset on video_out_clk
video_out_tdataoutMAX_TDATA_WIDTHUG934 beat: VID_PPC pixels, pixel 0 in the LSBs
video_out_tvalidout1Held with the payload until tready
video_out_treadyin1May change on any clock
video_out_tuserout1Start of frame: first beat of the first line
video_out_tlastout1End of line: last beat of every line
pixel_type_outout8PIXEL_TYPE[7:0] on aclk, a register output; changes one clock after a write. 0x00 comes out as 0x18. Synchronize it before use in another clock domain, or leave it open
Table 3-8.Low-speed uplink.
PortDirWidthDescription
ls_tx_outout1Uplink bit stream to the CoaXPress driver on the FMC, 20.83 or 41.67 Mb/s