Document ID
APT-DS-CXP-DEV-0001
Revision
1.0
IP version
2.2.0
Release date
November 2026
Chapter 1: Overview

1.2Features

Link layer

  • CoaXPress 2.1 Device (JIIA CXP-001-2021)
  • CXP-1 to CXP-12: 1.25 to 12.5 Gb/s on one connection
  • IDLE word at least every 100 words, as CoaXPress 2.1 requires
  • Uplink receiver with byte and word lock, following 20.83 and 41.67 Mb/s by itself
  • Line rate change in hardware: DRP rewrite, PLL reset, retries and an error code
  • GTH, GTY, or GTH transmitter only; wrapper supplied with the core

Protocol

  • Rectangular image header and line markers built from registers, taken at stream on
  • Stream packets up to StreamPacketSizeMax, with tag and CRC
  • Control commands received into a FIFO for firmware; acknowledges built from registers
  • Event packets built from registers; the Host’s acknowledge reported
  • Heartbeat with a 64-bit nanosecond time stamp and the Host ID
  • Triggers both directions, uplink triggers acknowledged by the core or by firmware; connection test

Video input

  • UG934 AXI4-Stream video slave: tuser start of frame, tlast end of line, on its own clock
  • 2 or 4 pixels per beat, 8 to 16 bits per component, 1 to 3 components per pixel
  • Mono, Bayer and Raw; RGB; YCbCr 4:4:4, 4:2:2 and 4:2:0; 8, 10, 12, 14 and 16-bit on the link
  • Each layout and bit depth built only when switched on in the IP GUI
  • Format selected at run time by one register write
  • Line and frame size checked against the image header

Integration

  • AXI4-Lite control in a 4 KB window with ID, version and build discovery
  • Interrupt controller with status, enable, pending and software test registers
  • Word, register, uplink and video clocks independent; all crossings inside the core
  • Packaged for Vivado IP Integrator with a customization GUI
  • Firmware driver for MicroBlaze, Zynq-7000 and Zynq UltraScale+ MPSoC
  • Example designs on ZCU106 with the APT-C11-FMC CoaXPress card