| Standard | JIIA CXP-001-2021, CoaXPress 2.1, Device link layer |
|---|---|
| Connections | 1 (one coax). Builds for 2 and 4 connections on request |
| Speeds | CXP-1, CXP-2, CXP-3, CXP-5, CXP-6, CXP-10, CXP-12: 1.25 to 12.5 Gb/s, changed at run time |
| Uplink | 20.83 and 41.67 Mb/s, received through the CoaXPress front end on the board |
| Transceiver | AMD UltraScale+ GTH (GTHE4), GTH transmitter only, or GTY (GTYE4), through the supplied transceiver wrapper |
| Video input | AXI4-Stream slave, AMD UG934 video convention, on its own clock |
| Bus | 2 or 4 pixels per beat (VID_PPC), 8 to 16 bits per component (VID_BPC), 1 to 3 components (VID_CPP); tdata 16 to 192 bits, default 64 |
| Pixel formats | Mono / Bayer / Raw, RGB, YCbCr 4:4:4, 4:2:2, 4:2:0 (sent as 4:2:2); 8, 10, 12, 14, 16-bit on the link; up to 25 per build |
| Pixel rate | Up to 1,220 Mpx/s on one CXP-12 connection (Mono 8-bit, 4 pixels per beat) |
| Protocol | Stream with image header, control acknowledges (tagged and untagged), events, heartbeat, triggers both directions, connection test |
| Control interface | AXI4-Lite slave, 32-bit data, 12-bit address (4 KB), 57 registers |
| Interrupt | cxp_dev_int, 14 sources, level with a re-arm gap after each status write |
| Clocks | Word clock from the transceiver = line rate / 40 (312.5 MHz at CXP-12); AXI4-Lite clock 50 to 250 MHz; video and uplink clocks independent |
| Target devices | AMD Zynq UltraScale+ MPSoC, Kria K26 SOM and Kintex UltraScale+; other UltraScale+ devices with GTH or GTY transceivers |
| Software | Firmware driver for MicroBlaze, Zynq-7000 and Zynq UltraScale+ MPSoC, supplied on purchase |
| Design flow | AMD Vivado Design Suite, IP Integrator or RTL instantiation |
Data Sheet
CoaXPress 2.1 Device IP Core
- Document ID
- APT-DS-CXP-DEV-0001
- Revision
- 1.0
- IP version
- 2.2.0
- Release date
- November 2026
Chapter 1: Overview