Document ID
APT-DS-CXP-HOST-0001
Revision
1.0
IP version
2.2.1
Release date
November 2026
Chapter 1: Overview

1.2Features

Link layer

  • CoaXPress 2.1 Host (JIIA CXP-001-2021), with untagged commands for discovery
  • CXP-1 to CXP-12: 1.25 to 12.5 Gb/s on one connection
  • Low-speed uplink at 20.83 Mb/s, and 41.67 Mb/s for CXP-10 and CXP-12
  • Lock on IDLE words, packet framing and CRC check on every packet
  • Line rate change in hardware: DRP rewrite, PLL reset, retries and an error code
  • GTH (GTHE4) or GTY (GTYE4) transceiver, wrapper supplied with the core

Protocol

  • Control channel: read and write commands, tagged (CXP 2.x) or untagged, acknowledge FIFO
  • Event packets into a FIFO, acknowledged by software or by the core
  • High-speed triggers from the camera, acknowledged by the core or by software; triggers to the camera on the uplink
  • Heartbeat with the camera’s time stamp and Host ID check
  • Connection test packets in both directions with counters
  • Image header and line markers parsed, line and frame size checked against the header

Video output

  • UG934 AXI4-Stream video: tuser start of frame, tlast end of line, on its own clock
  • 2 or 4 pixels per beat, 8 to 16 bits per component, 1 to 3 components per pixel
  • Mono, Bayer and Raw; RGB; YCbCr 4:4:4, 4:2:2 and 4:2:0; 8, 10, 12, 14 and 16-bit
  • Each layout and bit depth built only when switched on in the IP GUI
  • Format selected at run time by one register write, also driven on a port for the logic behind the core
  • Overflow, line width and format errors counted, never passed on silently

Integration

  • AXI4-Lite control in a 4 KB window with ID, version and build discovery
  • Interrupt controller with status, enable, pending and software test registers
  • Word, register and video clocks fully independent; all crossings inside the core
  • Packaged for Vivado IP Integrator with a customization GUI
  • Software driver for setup and control on MicroBlaze, Zynq-7000 and Zynq UltraScale+ MPSoC
  • Example designs on ZCU106 and KCU116 with the APT-C11-FMC CoaXPress card