Document ID
APT-DS-CXP-HOST-0001
Revision
1.0
IP version
2.2.1
Release date
November 2026
Chapter 1: Overview

1.3Key specifications

Table 1-1.Key specifications of the CoaXPress 2.1 Host IP Core v2.2.1.
StandardJIIA CXP-001-2021, CoaXPress 2.1, Host link layer
Connections1 (one coax). Builds for 2 and 4 connections on request
SpeedsCXP-1, CXP-2, CXP-3, CXP-5, CXP-6, CXP-10, CXP-12: 1.25 to 12.5 Gb/s, changed at run time
Uplink20.83 Mb/s; 41.67 Mb/s at CXP-10 and CXP-12
TransceiverAMD UltraScale+ GTH (GTHE4) or GTY (GTYE4), through the supplied transceiver wrapper
Video outputAXI4-Stream, AMD UG934 video convention, on its own clock
Bus2 or 4 pixels per beat (VID_PPC), 8 to 16 bits per component (VID_BPC), 1 to 3 components (VID_CPP); tdata 16 to 192 bits, default 64
Pixel formatsMono / Bayer / Raw, RGB, YCbCr 4:4:4, 4:2:2, 4:2:0; 8, 10, 12, 14, 16-bit on the link; up to 25 per build
Pixel rateUp to 1,220 Mpx/s on one CXP-12 connection (Mono 8-bit, 4 pixels per beat)
ProtocolStream, control (tagged and untagged), events, heartbeat, triggers both directions, connection test
Error accounting22 error counters with sticky flags, 11 statistics counters, last image header in registers
Control interfaceAXI4-Lite slave, 32-bit data, 12-bit address (4 KB), 83 registers
Interruptcxp_int, 14 sources, level with a re-arm gap after each status write
ClocksWord clock from the transceiver = line rate / 40 (312.5 MHz at CXP-12); AXI4-Lite clock 50 to 300 MHz; video clock independent
Target devicesAMD Zynq UltraScale+ MPSoC, Kria K26 SOM and Kintex UltraScale+; other UltraScale+ devices with GTH or GTY transceivers
SoftwareDriver for setup and control on MicroBlaze, Zynq-7000 and Zynq UltraScale+ MPSoC, supplied on purchase; Linux driver and application with the PCIe example design
Design flowAMD Vivado Design Suite, IP Integrator or RTL instantiation