- Configuration is quasi-static.
PIX_BIT,LINE_LENGTH,ECC_OPTION,CRC_OPTIONandECC_BLOCKreach the link as one word, but not aligned to a packet. Write them while the sensor is idle. The crop registers are sampled at Frame Start and may be written at any time. - Line Length. Program the sensor’s pixels per line: a multiple of 4 at 1, 2, 4 and 6 lanes, a multiple of 8 at 8 lanes. A Line Length that is not a multiple of 2 x LANE_NUM ends on a partial beat whose upper containers carry non-image data.
- Payload protection. Keep CRC Option on in the CRC build and ECC Option 1 or 2 in the ECC build; the sensor must be set the same way. The driver warns at stream start when it is off.
- ECC_BLOCK. Keep it programmed in the ECC build even when the sensor carries the line length in the packet header.
- NATIVE line buffer. Size the Output FIFO so Line Length / (2 x LANE_NUM) is at most depth - 32 beats after the crop.
- Inter-packet codes. The sensor must send Idle, Pad or Deskew Codes between packets as the standard requires; all Sony SLVS-EC sensors do. At 8 lanes a packet whose End Code runs straight into the next Start Code is lost.
Data Sheet
SLVS-EC Receiver IP Core
- Document ID
- APT-DS-SLVS-RX-0001
- Revision
- 2.1
- IP version
- 3.4.1
- Release date
- November 2026
Chapter 3: Interfaces and Timing