Table 3-2.Ports between the core and the bundled PHY (APT-SLVS-EC GT Wizard or SLVS-EC HP I/O). Connect them as in the example designs.
| Port | Dir | Width | Description |
| data_i | in | 16 x LANE_NUM | Decoded lane data from the PHY |
| rxdatak_i | in | 2 x LANE_NUM | Control-character flags from the PHY |
| data_clk_i | in | 1 | Lane clock from the PHY, line rate / 20 |
| rstn_i | in | 1 | Active-low synchronous reset on data_clk_i. Hold low until the PHY reports the lanes ready |
Table 3-3.Register interface S_AXI. Present in every build.
| Port | Dir | Width | Description |
| axi_aclk | in | 1 | Register clock, independent of every other clock |
| axi_aresetn | in | 1 | Active-low synchronous reset on axi_aclk; resets every RW register to 0 |
| axi_aw* / axi_w* / axi_b* | in/out | addr 8, data 32 | Write channels. WSTRB is honoured; BRESP is always OKAY; AWPROT is ignored |
| axi_ar* / axi_r* | in/out | addr 8, data 32 | Read channels. RRESP is always OKAY; unused offsets read 0 |
One write and one read are in flight at a time, and BREADY or RREADY
backpressure never loses a response. The IP reserves a 4 KB address range in the Vivado address
editor; the registers occupy the first 256 bytes.
Table 3-4.AXI4-Stream video master M_AXIS.
| Port | Dir | Width | Description |
| m_axis_aclk | in | 1 | Stream clock, any frequency, no phase relation to data_clk_i |
| m_axis_aresetn | in | 1 | Active-low synchronous reset on m_axis_aclk; may be pulsed at any time |
| m_axis_tdata | out | 32 x LANE_NUM | 2 x LANE_NUM pixels in 16-bit MSB-justified containers, earliest pixel in bits 15:0 |
| m_axis_tvalid | out | 1 | Held with the payload until tready; low during reset |
| m_axis_tready | in | 1 | May change on any clock |
| m_axis_tuser | out | 1 | Start of frame: first beat of the first line of a frame |
| m_axis_tlast | out | 1 | End of line: last beat of every line |
There is no tkeep or tstrb: every beat is a full beat. Put an AXI4-Stream data
width converter or subset converter behind the core when the sink wants a different number of pixels
per beat or 8-bit components.
Table 3-5.Native video master vid_io_out, on data_clk_i.
| Port | Dir | Width | Description |
| vid_data | out | 32 x LANE_NUM | 2 x LANE_NUM pixels per clock, same format as m_axis_tdata |
| vid_active_video | out | 1 | High for every beat of a line, no gaps inside a line |
| vid_hblank | out | 1 | High outside a line; the inverse of vid_active_video |
| vid_vblank | out | 1 | High between frames |
| vid_hsync | out | 1 | 1-clock pulse at the start of horizontal blanking after each line |
| vid_vsync | out | 1 | 4-clock pulse at the start of vertical blanking after each frame |
| vid_field_id | out | 1 | Always 0, progressive |
Table 3-6.AXI4-Stream master M_AXIS_EBD. Available with either video output.
| Port | Dir | Width | Description |
| m_axis_ebd_aclk | in | 1 | Embedded data stream clock, any frequency, no phase relation to data_clk_i; may be the same clock as m_axis_aclk |
| m_axis_ebd_aresetn | in | 1 | Active-low synchronous reset on m_axis_ebd_aclk; may be pulsed at any time |
| m_axis_ebd_tdata | out | 32 x LANE_NUM | 2 x LANE_NUM 16-bit words, MSB-justified at Pixel Bit: the image beat format |
| m_axis_ebd_tvalid | out | 1 | Held with the payload until tready; low during reset |
| m_axis_ebd_tready | in | 1 | May change on any clock. Tie high if the metadata is not read |
| m_axis_ebd_tuser | out | 1 | First embedded data beat after a Frame Start: one frame’s embedded data starts here |
| m_axis_ebd_tlast | out | 1 | Last beat of every embedded data line |