Data Sheet
SLVS-EC Receiver IP Core
- Document ID
- APT-DS-SLVS-RX-0001
- Revision
- 2.1
- IP version
- 3.4.1
- Release date
- November 2026
Chapter 4
Register Map
Twenty-four 32-bit registers on AXI4-Lite: identification, link configuration, error counters, video output and embedded data output, with bit fields, reset values and the programming sequence.
- 4.1Register interface
- 4.2Register summary
- 4.3IdentificationRead ID and VERSION before any write: they confirm the base address and the release. HWCFG tells software how the IP was built, so one driver handles CRC and ECC builds, every...
- 4.4Link configurationThese registers mirror the SLVS-EC Configuration Register of the sensor. They are quasi-static: write them while the sensor is idle, before it starts streaming.
- 4.5Error countersHeader CRC16 failures are counted in both builds, as bad copies and as lost headers. The CRC build counts payload CRC32 failures and keeps the Line Number of the last failing...
- 4.6Video outputThese registers control and report the video output stage: the crop, the frame counter and the output overflow status. VID_CTRL also holds the two embedded data output controls.
- 4.7Embedded data outputPresent when the embedded data output is built (HWCFG.EBD_OUT = 1). Without it both read 0 and the two VID_CTRL bits have no effect, so software that finds HWCFG.EBD_OUT = 0...
- 4.8Programming ECC_BLOCKIn the ECC build each line payload is split into Basic Blocks of 224 information bytes and a last block with the remainder. ECC_BLOCK tells the core where the last block starts....
- 4.9Programming sequenceThe same sequence with plain register accesses, for a 2-lane CRC build receiving 5328-pixel RAW12 lines with the CRC footer, cropped to 1920 x 1080: