Document ID
APT-DS-CXP-DEV-0001
Revision
1.0
IP version
2.2.0
Release date
November 2026
Chapter 2: Functional Description

2.8Line rate change

The frame grabber discovers the camera at a low speed and moves it to the operating speed with ConnectionConfig. When firmware has acknowledged that write, it writes the new speed code and CXP_RATE_TRANS.APPLY. The core then

  1. Rewrites the transmitterDRP writes to the channel and common PLL for the new rate, from tables built into the core for each transceiver option.
  2. Resets itA PLL and datapath reset on reset_TX_PLL, held at least the minimum time.
  3. Waits for itThe transmitter must take the reset and report reset done within the timeouts set in the IP GUI; the core retries the reset up to the configured number of times.
  4. ReportsTX_READY when the transmitter is back, or RATE_ERR with an error code in CXP_STATUS[15:14].

A request is taken in any state, also with the transmitter down, and a request during a change runs next (newest wins). The core refuses rate code 7 with SLVERR.

Table 2-6.Line rate change error codes, CXP_STATUS[15:14]. After an error the core is idle again and takes the next request.
CodeMeaningWhat to check
1DRP no answerThe transceiver did not answer the DRP writes in time. The transceiver is not reset; check the DRP clock and connection.
2Reset not acknowledgedThe transceiver wrapper never took the PLL and datapath reset: reset_TX_PLL is not connected to it.
3Reset done never backtransmitter reset done did not return after the retries: the PLL is not locking (reference clock, or the board).