Document ID
APT-DS-CXP-DEV-0001
Revision
1.0
IP version
2.2.0
Release date
November 2026
Chapter 2: Functional Description

2.2Transceiver and link

The core runs on an AMD UltraScale+ transceiver, selected with Transceiver in the IP GUI:

Table 2-1.Transceiver options.
OptionUsesUse it when
GTH, transmitter only defaultThe transmit side of a GTH channelThe receivers of the quad serve something else, such as the lanes of an SLVS-EC sensor
GTHA GTH channelZynq UltraScale+ MPSoC, Kria and Kintex devices with GTH
GTYA GTY channelKintex and Virtex UltraScale+ devices with GTY

The transceiver wrapper is delivered with the core, set up for CoaXPress: line rates, 8b/10b and the DRP rate tables the core uses for a line rate change. The coax needs a CoaXPress cable driver and an uplink receiver between the FPGA and the connector, as on the APT-C11-FMC; the core takes the uplink bit stream on ls_rx_in with its clock on ls_clk_ddr.

  • Downlink. At least one IDLE word every 100 words (Words between IDLE words, 99 by default as CoaXPress 2.1 allows; 64 and 32 are available). Packets are sent by priority: triggers first, then acknowledges, events, heartbeats and stream data.
  • Uplink. The receiver finds byte lock, then word lock on IDLE words, and follows 20.83 and 41.67 Mb/s by itself. LS_RX_ALIGNED reports a Host on the line; loss of byte or word lock raises its own interrupt. The lock thresholds are set on the Advanced page of the IP GUI.
  • Connections. The IP package builds one connection. Builds with 2 and 4 connections are available on request.