Document ID
APT-DS-CXP-HOST-0001
Revision
1.0
IP version
2.2.1
Release date
November 2026
Chapter 2: Functional Description

2.1Architecture

The core is the Host link layer. The supplied transceiver wrapper recovers the clock and the 8b/10b words from the coax; the core takes 32-bit words and their K flags from there, on the word clock of the transceiver. Every packet passes the stages below. Video leaves on an AXI4-Stream on your clock; everything else is handed to software through the register file.

rx_outclk2 (word clock = line rate / 40) from thetransceiver32-bit wordsand K flags Link receive IDLE word lock packet framing CRC check Packet sort stream, control ack event, heartbeat trigger, test Stream parse image header line markers size checks Pixel unpack 8 to 16-bit link gearbox zero pad strip Beat layout Mono, Bayer RGB, YCbCr VID_PPC x BPC Video FIFO AXI4S_DEPTH video_outAXI4-Streamvideo_out_clk pixel_type_outto the packer Ack + event FIFOs to software Line rate control DRP writes, PLL reset, retries Uplink TX commands, triggers, acks ls_tx_out20.83 / 41.67Mb/s clock-domain crossing: configuration down, status, counters and packets up (inside the core) aclk (AXI4-Lite) AXI4-Lite register file and interrupt controller ID, build | interrupts | video | link | control | events | counters s_axicxp_int word clock domainaclk domainvideo clock side of the FIFOdata path
Figure 2-1.Functional block diagram. The receive path runs on the transceiver word clock; the register file and the interrupt controller run on the AXI4-Lite clock; the video FIFO is read on the video clock. All crossings are inside the core.
  1. Link receiveAligns the words on the IDLE word, declares lock after a run of good IDLE words, frames packets on their K codes and checks the CRC of every packet.
  2. Packet sortSends stream packets to the stream path, and control acknowledges, events, heartbeats, triggers and test packets to their own handlers, FIFOs and interrupts.
  3. Stream parseChecks stream packet tags and sizes, takes the rectangular image header and the line markers, and checks every line and frame against the header.
  4. Pixel unpackTurns the link words back into components of the selected bit depth, 8 to 16 bits, and drops the zero padding at the end of each line.
  5. Beat layoutPlaces the components on the UG934 beat: VID_PPC pixels of VID_BPC-bit components, in the order of the selected layout.
  6. Video FIFOCrosses to the video clock and drives video_out with tuser at the start of each frame and tlast at the end of each line.