Document ID
APT-DS-CXP-HOST-0001
Revision
1.0
IP version
2.2.1
Release date
November 2026
Chapter 2: Functional Description

2.11Clocks and reset

Table 2-8.Clock domains.
ClockSourceRuns
rx_outclk2Word clock from the transceiver wrapper: line rate / 40, 312.5 MHz at CXP-12; changes with the speedThe receive path, parser and pixel path
aclkFree-running clock, 50 to 300 MHz, set in the GUI so the line rate change timeouts are rightRegister file, interrupt controller, line rate change
video_out_clkThe clock of the block that takes the video, any frequency that carries the pixel rateThe read side of the video FIFO and video_out
drp_clkOutput of the core to the transceiver wrapperDRP accesses for the line rate change
  • Clock aclk from a free-running clock. The registers stay readable while the link is down, and software reads ID and VERSION at boot before any camera is plugged in.
  • Every crossing uses AMD XPM macros and constrains itself. Enable the XPM libraries in the project; do not add clock groups or false paths between these clocks.
  • reset_PLL must reach the PLL and datapath reset of the transceiver wrapper, as in the example designs. Without it a line rate change ends with error code 2 or 3.
  • RST_CXP pulses resets for the whole core, the high-speed paths and the uplink, so software can recover any part without a reconfiguration.