Document ID
APT-DS-CXP-HOST-0001
Revision
1.0
IP version
2.2.1
Release date
November 2026
Chapter 2: Functional Description

2.8Line rate change

CoaXPress starts at a discovery speed and moves to the operating speed once the camera has been configured. In the Host core that is one register write: set the speed code and CXP_RATE_TRANS.APPLY. The core then

  1. Rewrites the transceiverDRP writes to the channel and common PLL for the new rate, from tables built into the core for GTH or GTY.
  2. Resets itA PLL and datapath reset on reset_PLL, held at least the minimum time.
  3. Waits for itThe transceiver must take the reset and report reset done within the timeouts set in the IP GUI; the core retries the reset up to the configured number of times.
  4. ReportsRATE_DONE, or RATE_ERR with an error code in CXP_STATUS[15:14]. RATE_CHANGE_CNT counts completed changes.

A request is taken in any state, also with the transceiver down, and a request that arrives during a change runs next (newest wins). The timeouts are set in the GUI as times; the GUI converts them with the AXI4-Lite clock frequency.

Table 2-6.Line rate change error codes, CXP_STATUS[15:14]. After an error the core is idle again and takes the next request.
CodeMeaningWhat to check
1DRP no answerThe transceiver did not answer the DRP writes in time. The transceiver is not reset; check the DRP clock and connection.
2Reset not acknowledgedThe transceiver wrapper never took the PLL and datapath reset: reset_PLL is not connected to it.
3Reset done never backreset done did not return after the retries: the PLL is not locking (reference clock, or the board).