Document ID
APT-DS-SLVS-RX-0001
Revision
2.1
IP version
3.4.1
Release date
November 2026
Chapter 2: Functional Description

2.8Framing and crop

Both outputs deliver clean frames:

  • One frame per Frame Start. Lines that arrive before the first Frame Start after reset are dropped, so the first thing out is always a whole frame.
  • Image lines only. Embedded data lines go to the embedded data output when it is built; blanking packets are always removed.
  • Every line is cut at Line Length, including the Frame End line, so stuffing and footer bytes never appear as pixels.
  • Three crop registers remove lines and columns, applied from the next Frame Start.
VID_LINE_SKIP image linesskippedOutput imageVID_WIDTH x VID_HEIGHTcolumns past VID_WIDTHdeliveredremaining linesdroppedVID_WIDTH (from pixel 0)VID_HEIGHTFrame StartLine Length pixels
Figure 2-7.What reaches the output. The crop values are sampled at each Frame Start, so they can be changed while the sensor streams.
Table 2-8.Crop registers. All three reset to 0, which delivers the full image.
RegisterOffsetEffect
VID_LINE_SKIP0x30Image lines dropped at the start of every frame
VID_WIDTH0x34Pixels kept from pixel 0 of each line, rounded up to a whole beat of 2 x LANE_NUM pixels; 0 = whole line
VID_HEIGHT0x38Lines kept after the skip; 0 = all lines to Frame End

Example: an IMX530 window on 2 lanes, 5328 pixels wide, cropped to 1920 x 1080 starting at line 8: VID_LINE_SKIP = 8, VID_WIDTH = 1920, VID_HEIGHT = 1080, which gives 480 beats per line. The crop keeps the left part of the line; move the window horizontally with the sensor's own region-of-interest registers.