Document ID
APT-DS-SLVS-RX-0001
Revision
2.1
IP version
3.4.1
Release date
November 2026
Chapter 2: Functional Description

2.6Video outputs

One parameter, Output (OUT_MODE), selects which video interface is built. Only the ports of the selected output appear on the IP. Both carry the same pixel format and the same frames.

Table 2-6.Choosing an output.
OutputUse it whenClockBuffer
AXI4S OUT_MODE 1The next block is an AXI4-Stream sink on its own clock: AXI VDMA, a frame buffer writer, an HLS pipeline, a PCIe DMA or a CoaXPress transmitterm_axis_aclk, any frequencyClock-crossing FIFO, absorbs tready stalls
NATIVE OUT_MODE 0The next block takes native video: AMD Video In to AXI4-Stream, or a pipeline on the lane clockdata_clk_iLine buffer, one line of latency

2.6.1AXI4S

An AXI4-Stream video master in the AMD video convention. tuser marks the first beat of every frame and tlast the last beat of every line. Between lines and frames tvalid is low; while the FIFO has room, tready may stall the stream at any time without losing data.

frame N frame N+1 m_axis_aclk m_axis_tvalid m_axis_tready m_axis_tdata B0 B1 B2 B3 B0 B1 B2 B3 B0 B1 B2 B3 B0 B1 B2 B3 m_axis_tuser m_axis_tlast line 0 line 1 line 2 frame gap next frame
Figure 2-4.AXI4S output over one frame of three short lines (4 beats each), then the first beats of the next frame. Every port of the interface is shown.

2.6.2NATIVE

Native video with the signal set AMD video IP expects. Each line leaves as one unbroken run of vid_active_video; vid_hsync pulses after every line and vid_vsync after every frame, at the start of the blanking that follows.

frame N (vid_vblank low) frame N+1 data_clk_i vid_vblank vid_hblank vid_active_video vid_hsync vid_vsync vid_field_id vid_data line 0 line 1 line 2 line 0 active hblank vertical blanking
Figure 2-5.NATIVE output over one frame of three short lines, the vertical blanking, and the start of the next frame. Every port of vid_io_out is shown.

Clock-by-clock timing for both outputs is in Output timing.